40706-1608
3 14
INSTALLING THE BATTERIES
NOTE: Do not mix old and new batteries. Do not
mix alkaline, standard or rechargeable batteries.
After removing the drawer, push the battery cover
locking tab with a screwdriver to release the cover.
Install the (4) AA alkaline batteries as shown.
Replace the cover by inserting the rear tabs in the
slots and snapping the cover in place.
NOTE: If the batteries are low the combination
buttons will flash red when pushed. Replace with
4 new AA alkaline batteries as shown.
• For security you must program your own
combination after opening the safe.
• Record your new combination on this form
or store your combination on our secure
website at stack-on.com under Customer
Service. If you write down your combination
you must keep this information in a secure
place, away from children, not inside the safe.
PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
1.
2.
Press the Reset Button (3) located inside the safe.
Two “beeps” will sound (if the sound is turned
on) and all 3 buttons will flash blue twice. You
will have 5 seconds to begin entering your
combination or you will have to start over.
Example: (RIGHT) - (LEFT) - (CENTER) -
(LEFT) - (RIGHT)
For each combination entry a “beep” will sound
(if the sound is turned on) and all the buttons
will light up green. If you delay more than 5
seconds between entries you will have to start
over from step 1. After you have finished
entering your combination, you will have 5
seconds to press the Reset Button to record
your new combination or you will have to start
over from step 1.
Enter your own 3-8 button combination by
pressing any combination of the 3 buttons.
3.
When you press the Reset Button to record
your new combination, there will be two
“beeps” (if the sound is turned on) and all 3
keys flash blue twice, indicating your new
combination has been recorded.
Reset Button
