40790-1803
3 14
•
For security you must program your own
combination after opening the safe.
•
Record your new combination on this form or
store your combination on our secure website
at stack-on.com under Customer Service. If you
write down your combination you must keep
this information in a secure place, away from
children, not inside the safe.
PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
1.
2.
Press the Reset Button located inside the
safe. Two “beeps” will sound (if the sound is
turned on) and all 3 buttons will flash blue
twice. You will have 5 seconds to begin
entering your combination or you will
have to start over.
Example: (RIGHT) - (LEFT) - (CENTER) -
(LEFT) - (RIGHT)
For each combination entry a “beep” will
sound (if the sound is turned on) and all the
buttons will light up green. If you delay
more than 5 seconds between entries you
will have to start over from step 1. After
you have finished entering your
combination, you will have 5 seconds to
press the Reset Button to record your new
combination or you will have to start over
from step 1.
Enter your own 3-8 button combination by
pressing any combination of the 3 buttons.
3.
When you press the Reset Button to
record your new combination, there will
be two “beeps” (if the sound is turned on)
and all 3 keys flash blue twice, indicating
your new combination has been recorded.
Reset Button
INSTALLING THE BATTERIES
NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard or
rechargeable batteries.
NOTE: If the batteries are low the indicator light
will flash blue when you start scanning. Replace
with 4 new AA alkaline batteries as shown.
If your safe includes a shelf, remove it for better
access to the battery compartment. Push the
battery cover locking tab with a screwdriver to
release the cover. Install the (4) AA alkaline
batteries as shown. Replace the cover by
inserting the rear tabs in the slots and snapping
the cover in place.
