40717-1704
2 16
BATTERY
INSTALLATION
TAB
You must first install the batteries which are
located in the front protective Styrofoam.
This safe uses 4 - AAA batteries. Under normal
use, batteries will last about 1 year.
NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard or
rechargeable batteries.
NOTE: When changing or installing the
batteries, do not pull on the wires. Doing
this could cause the power supply to become
disconnected from the lock.
NOTE: If the batteries are low, the green and
red indicator lights will flash together when
you start scanning. Replace with 4 new AAA
alkaline batteries.
To replace the batteries, remove the lock
faceplate by pressing the tab and turning the
cover as shown in the illustration below.
Batteries
1
2
BACK VIEW
Battery
cover
Battery
cover
Open the battery compartment located on the
back of the lock faceplate as shown below.
After batteries are installed, reattach the
faceplate by twisting it on in the opposite
direction of the illustration on previous page.
