IMPORTANT:
Your safe is delivered with a Safety
Interlock Screw which must be
removed in order for you to lock your
safe. Failure to do so will
compromise the safety and security
of your safe.
First open the safe by turning the handle
clockwise and pulling the door open.
Locate the Safety Interlock Screw on the side of
the door; unscrew with a Phillips screwdriver,
remove and discard the screw.
Your safe can now be closed and locked.
Do not lock your instruction manual and/or keys
in the safe. You will need this manual for the
instructions on locking and unlocking the safe.
Safety Interlock Screw
40676-1605
2 20
BATTERY
INSTALLATION
TAB
You must first install the batteries which are
located in the front protective Styrofoam.
This safe uses 4 - AAA batteries. Under normal
use, batteries will last about 1 year.
NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard or rechargeable
batteries.
NOTE: When changing or installing the
batteries, do not pull on the wires. Doing this
could cause the power supply to become
disconnected from the lock.
NOTE: If the batteries are low, the yellow light
will flash when you press the scanner.
To replace the batteries, remove the lock faceplate
by pressing the tab and turning the cover as shown
in the illustration below.
