The safe has a UL Listed interior electrical outlet
that can be connected to an exterior 110V-15A
power source only.
ELECTRICAL OUTLET
Install the exterior power cord into the electrical
outlet in the back of the safe.
NOTE: For easy access, install the power cord
before securing the safe to the floor.
40676-1605
4 20
OPENING THE SAFE USING
YOUR FINGERPRINT
To open the safe, press the scanner with a recorded
finger. The blue light will come on with one beep (if
the sound is turned on) and the scan will begin.
If the green light flashes twice with 2 beeps (if the
sound is turned on), the scan has been accepted and
you will have 5 seconds to turn the handle to open
the door.
If the red light flashes once, the scanner did not read
your fingerprint and you must try again. If the red
light flashes 3 times, the scanner read your fingerprint
and did not accept it.
If there are 3 rejected scans, where your
fingerprint was read, and the red light flashes 5
times with 5 beeps (if the sound is turned on),
you will have an automatic lockout for 60
seconds before you can try a scan again. The
safe will beep one time (if the sound is turned
on) and the green light will flash once when the
lockout period is over.
If there is 1 more rejected scan where your
fingerprint was read and the red light flashes 5 times
with 5 beeps (if the sound is turned on), you will
have an automatic lockout for 5 minutes before you
can try a scan again. The safe will beep one time (if
the sound is turned on) and the green light will flash
once when the lockout period is over.
SELECTING A LOCATION
The safe should be flat against the wall and floor.
Remove the baseboard if necessary.
The safe must be mounted to the floor. For
optimal safety and security, the safe should be
installed adjacent to a side wall with minimal
space on either side of the safe, in an isolated,
dry and secure area.
CHILDREN SHOULD NOT PLAY
WITH OR AROUND THE SAFE AT
ANY TIME.
LOCKING THE SAFE
To lock the safe, close the door and rotate the
handle counter clockwise until it stops. If the
handle is not turned until it stops, the locking
mechanism will not lock.
TURNING THE SOUND OFF/ON
To turn the sound off, press the scanner with a
recorded fingerprint for 10 seconds until the green
light flashes twice.
To turn the sound on, press the scanner with a
recorded fingerprint until you hear two beeps and
the green light flashes twice.
Your safe comes with the beep sound turned on.
