HOW TO CONFIGURE THE CONSOLE continued
24
HOW TO PERFORM A ZERO RESET
1. Activate the console and go to the SETTINGS
MODE.
See HOW TO ACTIVATE THE CONSOLE on page 11.
Then, see HOW TO USE THE SETTINGS MODE on
page 20
2. Select Zero Reset
To Select ZERO RESET, press and hold the BACK-
LIGHT and AVG/END buttons for 5 seconds. ZERO
RESET will appear on the message banner.
Note:
In pairing mode, once a power meter is
successfully paired with the console, the console
will navigate directly to this menu option.
3. Position Power Meter
IMPORTANT: Zero reset should only be
performed when the power meter is installed
on the bike.
Rotate the power meter at least one revolution to
ensure that it is awake and ready to communi-
cate.
Position the power meter vertically (6 o’clock),
and ensure that there is no load on the pedals
and the bike is stable.
Note:
If the power meter moving or is not
positioned vertically the zero reset will fail.
4. Perform Zero Reset by pressing the STAGE
button.
The console will
countdown for 60
seconds or until it
successfully performs
the zero reset.
5. Complete the zero reset process
If the zero reset is success-
ful, the word SUCCESS will
appear in the message
banner along with a
random number below it.
The console will then
return to the STARTUP mode.
Note:
The displayed zero reset value will NOT be
zero but rather a number that corresponds to the
measurement taken by the sensor.
If the zero reset fails, the
word FAILED, will appear
in the message banner.
Go to step 6.
