Istruzioni Instructions Anleitungen
13
Manual Manoeuvre
•
The manual manoeuvring of the arm should
only be carried out when the motor has
stopped due to a cut in the power supply
•
Pull off the self releasing cylinder (1) and with
the Alan key (2) unblock the motor turning the
key in an anticlockwise direction.
•
To re start the transmission, insert the cylinder
with the red key inside it. Once it has reached
the mechanical stop keep the cylinder still and
pull the red key out.
•
Warning! Do not carry out the manual
manoeuvring if the arm is not fixed to the
motor.
Preliminary Checks
•
Make sure that the ground is ideal for holding the cement base, in which the foundation
plate will be mounted.
•
Make sure to foresee the passage of the cables as in the ideal set-up. The cable passage
is situated in a central position on the back of the barrier.
•
Make sure that there are no obstacles in the way of the arm’s radius that could stop it’s
movement.
Fixing of the foundation plate (Fig. 2)
The barrier can be positioned either to the right or to the left of the passage. Therefore, once
decided the correct position proceed to the following steps:
•
Prepare a cement base where you can insert the foundation plate with the relative rods.
•
Make sure that the plate is perfectly flat, that it’s surface is perfectly clean and that the
rods are precisely perpendicular to the ground.
Fig. 2
2
1
