132999 / 8102604300
2018-10-18·BA00·III·en·06
Mounting and Installation
13
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Junction Boxes
Series 8102
• Mount the device on a flat surface.
• The operating position is optional.
• Fasten the device to the mounting holes, provided for this purpose, using suitable
screws and accessories (see dimensional drawings).
7.3
Installation
The fastening holes are designed as elongated holes.
This allows vertical and horizontal adjustment during mounting.
DANGER
Explosion hazard due to impermissible cable entries!
Non-compliance results in severe or fatal injuries.
• Only use cable entries approved for the required type of protection.
• When selecting cable entries, observe the thread type and thread
size in the equipment documentation.
• Make sure that the conductor diameter matches the clamping
cross-section of the cable entries.
DANGER
Explosion hazard due to cable glands without strain relief!
Non-compliance results in severe or fatal injuries.
• Lead cables and conductors securely.
• If the cables are laid loosely, use only cable entries approved for
this type of cable laying.
For cable entries
(
M20 made of plastic special measures are required.
Please refer to the operating instructions of the cable entries for further
information.