133285 / 8118609300
2019-11-13·BA00·III·en·06
Product Selection, Project Engineering and Modification
9
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal Boxes
Series 8118/1, Series 8118/2
5.1
Additional Drilled Holes
5.1.1 Additional Drilled Holes by R. STAHL
Give the following information to R. STAHL:
- Type
- Data sheet
- Quantity, manufacturers and approvals of the components that are to be installed.
R. STAHL
• will check whether the components, drilled hole diameters, quantity and position
correspond with the approval
• will create the drilled holes
• will mount the components
• will update the order documentation
• will carry out a routine test
• will, if necessary, fit a new rating plate if the technical data has changed,
e.g. due to the components that are to be additionally installed.
5.1.2 Have the Customer create additional Drilled Holes
5.1.2.1 Enclosure
Calculate the usable area for cable entries in the enclosure
The calculation is performed in three steps:
Calculate the total usable area
Calculate the required area for cable entries
Calculate the remaining usable area.
1.) Calculate the total usable area
The total usable area for installation is calculated as follows:
(Length of the inner enclosure wall - 2 x 10 mm
*
) x
(Height of the inner enclosure wall - 2 x 10 mm
*
)
*2 x 10 mm = circumferential rim of the inner enclosure wall
Important for the following calculation:
Measure the dimensions on the plane surface inside of the enclosure
(not on the outside of the enclosure)
Consider additional space required for blind rivet nuts. The space requirement for the
built-in part is determined using the width across corners of the cable entry plus
additional space for the tool.
Summary of Contents for 8118/1 Series
Page 49: ......
