168471 / 815060300010
2018-03-06·BA00·III·en·05
Transport and storage
7
Empty Enclosure
Series 8150/0
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
4
Transport and storage
Transport and store the device carefully and in accordance with the safety notes
(see "Safety" section).
5
Product selection, project engineering and modification
DANGER! Explosion due to damaged seal in devices with enclosure hinges!
Non-compliance may result in serious or even fatal injury.
Devices with enclosure hinges must be transported only with a transport lock.
DANGER! Risk of explosion if the entire device is painted after manufacture!
Non-compliance may result in serious or even fatal injury.
Do not paint the device.
Have all repairs performed by the manufacturer.
DANGER! Explosion due to defective sealing of the device!
Non-compliance may result in serious or even fatal injury.
Do not drill any additional holes in order to apply labels or plates
(on the outside).
Additional holes may only be drilled by R. STAHL.
Equip the enclosure only with suitable equipment (e.g. cable entries, stopping
plugs, drain or breather valves) that is verifiably approved for use in hazardous
areas and meets the requirements of the IP protection rating. Examples:
EC Type Examination Certificate or IECEx Certificate of Conformity
Seal any unused cable entries with the stopping plugs approved for the type
of protection.
Seal all open drilled holes by means of suitable equipment.
NOTICE!
Non-compliance can result in material damage.
Acceptance testing for work performed by the customer must be carried out
in accordance with national regulations. Otherwise, you must have R. STAHL
or a test body (third-party inspection) (section 3.3.1) carry out acceptance testing.
This can be done by R. STAHL on request for a corresponding offer. If the work is
carried out by R. STAHL, no additional acceptance is necessary.
If customers intend to fit the components in the holes themselves, dust and transport
protection is provided for the openings in the enclosure (adhesive tape with a warning
note or plastic caps) ex-factory.
