Safety
6
202161 / 815060300020
2016-12-13·BA00·III·en·05
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal Box
Series 8150/1, Series 8150/2
Subsequently modifying the device, operating it outside of permitted conditions or cleaning it
improperly can cause it to heat up severely or to become electrostatically charged, resulting
in it producing sparks. This can result in explosions causing fatal or severe injuries
to persons.
Operate the device only within the prescribed operating conditions (see the type plate
and the "Technical data" chapter).
Devices which have a polyester powder coating must not be installed in areas containing
severely charge-producing processes.
Do not paint the device. Consult with R. STAHL before mending flaws such as scratches.
Comply with the area specification of EN IEC 60079-0 when fitting additional plastic
adhesive plates.
Clean the device only with a damp cloth.
Impairment of IP protection
When installed properly and completely, the device will have the required IP degree of
protection. Making structural changes to the device or mounting it improperly can impair
its IP protection. This can result in explosions causing fatal or severe injuries to persons.
Fit plates (on the outside) only without drilling any additional holes.
Only drill holes for cable glands exactly according to the instructions in the "Product
selection, project engineering and modification" and "Mounting" chapters of these
operating instructions. Consult with R: STAHL first if there are any discrepancies or
uncertainties.
Mount the device only in the prescribed mounting position. More detailed explanations
of this can be found in the "Mounting" chapter.
Improper installation, commissioning, maintenance or cleaning
Basic work such as installation, commissioning, maintenance or cleaning of the device must
be performed only in accordance with the valid national regulations of the country of use and
only by qualified persons. Otherwise the explosion protection can be rendered ineffective.
This can result in explosions causing fatal or severe injuries to persons.
Have mounting, installation, commissioning and maintenance performed only by qualified
and authorised persons (see section 3.2.).
Perform modifications to the device only in accordance with these operating instructions.
Have the modifications inspected and approved by R. STAHL or an inspection authority
(3rd party inspection).
Perform maintenance and repairs on the device only using original spare parts and after
consultation with R. STAHL.
Gently clean the device only with a damp cloth and without scratching, abrasive or
aggressive cleaning agents or solutions.
Never clean the device with a strong water jet, e.g. using a high-pressure washer!