Product selection, project engineering and modification
8
202161 / 815060300020
2016-12-13·BA00·III·en·05
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal Box
Series 8150/1, Series 8150/2
When complying with the installation conditions and specifications on the type plate:
Check whether enough cable entries are provided. Drill additional holes if necessary;
see sections 5.1 to 5.2.
Equip terminals and, if necessary, mount built-in components; see section 5.4.
The methods mainly considered for modification are subsequently machining or equipping
the terminal box. In this case, the following possibilities are available:
• Additional through holes on the flange plate, either by R. STAHL or by the customer
(section 5.1)
• Additional through holes in the enclosure, either by R. STAHL or by the customer
(section 5.2)
• External attached components either by R. STAHL or by the customer (section 5.3)
• Internal built-in components either by R. STAHL or by the customer (section 5.4)
5.1
Additional through holes in flange plates
5.1.1 Creation of additional drilled holes and through holes by R. STAHL
Forward the following information to R. STAHL:
- Type
- Data sheet
- Quantity, manufacturers and approvals of the components that are to be installed.
R. STAHL
• will check whether the components, drilled hole diameters, quantity and position
correspond with the approval
• will create the drilled holes and through holes
• will mount the components
• will update the order documentation
• will carry out a routine test
• will, if necessary, fit a new type plate if the technical data has changed,
e.g. due to the components that are to be additionally installed.
Work that has been carried out single-handedly must be inspected and approved in
accordance with national regulations. Otherwise it must be inspected and approved
by R. STAHL or an inspection authority (3rd party inspection) (section 3.3.1). R. STAHL
can do this on request and for appropriate remuneration. No additional inspection and
approval is required if the work is carried out by R. STAHL.