149915 / 8562606300
2012-08-16·BA00·III·en·06
Safety Instructions
3
Residual current circuit-breaker with
integral overcurrent protection
8562/5
3
Safety Instructions
The most important safety instructions are summarized in this section.
They supplement the corresponding regulations which the staff responsible must study.
When working in areas, subject to explosion hazards, the safety of personnel and plant
depends on complying with all relevant safety regulations. Assembly and maintenance
staff working on installations therefore have a particular responsibility.
They require precise knowledge of the applicable standards and regulations.
Use the devices
in accordance with their designated use
and for their intended
purpose only (see “Function“ on page 3).
Incorrect or impermissible use or non-compliance with these instructions invalidates our
warranty provision.
No modifications or alterations to the devices impairing their explosion protection are
permitted. The devices must only be fitted and operated if they are undamaged, dry and
clean.
4
Conformity to Standards
Conformity with standards and regulations is specified in the corresponding certificates
and declarations of the manufacturer (e.g. EC Declaration of Conformity).
These documents are available for download in the download area on the internet page
www.stahl-ex.com.
5
Function
The series 8562 residual current circuit-breaker with overcurrent protection is
used in hazardous areas and protects cables against overload and short-circuit,
and also personnel by limiting the duration of residual currents by switching off.
It is designed for fitting into an enclosure with type of protection “Increased safety e“.
As a user, please observe:
national safety and accident prevention regulations,
national assembly and installation regulations (e.g. IEC/EN 60079-14),
generally recognised technical regulations,
safety instructions and information in these operating instructions,
characteristic values and rated operating conditions on the rating and data plates,
instruction plates on the unit,
that any damage can invalidate the Ex-protection.
The devices are approved for use in hazardous areas of Zones 1 and 2.
Summary of Contents for 8562/54-246 Series
Page 2: ......
Page 3: ...Betriebsanleitung Fehlerstromschutz schalter mit Überstromauslöser 8562 5 ...
Page 29: ......
Page 30: ...149915 8562606300 2012 08 16 BA00 III de en 06 ...
