Stahl EXLUX L402/2 Series, Operating Instructions Manual

259910 / L40260300020

2017-09-18·BA00·III·en·00

Commissioning

17

Linear Luminaire with LED

Series EXLUX L402/2

EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN

7.3.3 Cable entries

The standard luminaire is delivered with 3 lead-in holes, 2 cable glands and 2 stopping 

plug.

Please observe the tightening torque for luminaires with installed cable glands and  

stopping plugs from R. STAHL Schaltgeräte GmbH.

Luminaires with cable glands and stopping plugs; not supplied by  

R. STAHL Schaltgeräte GmbH

Please note:

• the required temperature resistance!

• the IP degree of protection according to the rating plate!

• the operating instructions of the cable glands and stopping plugs!

• the required tightening torques!

• the range of the permissible cable diameter!

8

Commissioning

Before commissioning, ensure that

• the device has been installed according to regulations.

• the power supply voltage and the rated operational voltage are identical.

• the required cable diameter for cable glands has been used.

• the cable entries and stopping plugs have been securely tightened.

• the cables are correctly connected.

• the connection has been performed correctly.

• all screws and nuts are tightened according to regulations.

• the connection chamber is clean.

• the device is not damaged.

• no foreign bodies are inside the device.

• the device is sealed according to regulations.

• the LED assembly and the diffusor are clean.

Tightening torque
Connection thread

Pressure screw

Cable gland 8161

M20 x 1.5

2.3 Nm

1.5 Nm

M25 x 1.5

3.0 Nm

2.0 Nm

Stopping plugs 8290

M20 x 1.5

1.0 Nm

M25 x 1.5

1.5 Nm