255118 / 815060300340
2017-04-19·BA00·III·en·01
Safety
5
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal box
Series G150/1
3.2
Personnel qualification
Qualified specialist personnel are required to perform the tasks described in these operating
instructions. This primarily applies to work in the following areas:
• Product selection, project engineering and modification
• Mounting/dismounting the device
• Installation
• Commissioning
• Maintenance, repair, cleaning
Specialists who perform these tasks must have a level of knowledge that meets applicable
national standards and regulations.
3.3
Residual risks
3.3.1 Danger
Mechanical damage
The device can be pressed or scratched during transport, mounting or commissioning,
causing it to no longer be leak-tight. Such damage can, for example, render the device's
IP protection partially or fully ineffective.
Observe the weight and the maximum load-bearing capacity of the device;
see specifications on the packaging.
Transport the device only in the original packaging or in equivalent packaging.
Use transporting or lifting equipment which is suitable for the size and weight of the device
and can reliably carry the weight of the device.
Check the packaging and the device for damage. Report any damage to R. STAHL
immediately.
Store the device in the original packaging in a dry (no condensation) and stable position
which is safe from vibrations.
Do not damage the enclosure, built-in components or seals during mounting.
Excessive heat-up or electrostatic charge
Subsequently modifying the device, operating it outside of permitted conditions or cleaning it
improperly can cause it to heat up severely or to become electrostatically charged, causing
it to produce sparks.
Operate the device only within the prescribed operating conditions
(see the type plate and the "Technical data" chapter).
Devices which have a polyester powder coating must not be installed in areas containing
severely charge-producing processes.
Do not paint the device. Consult R. STAHL before mending flaws such as scratches.