Assembling and Dismantling
6
212485 / 7579615300
2011-09-13·BA00·III·en·00
SolConeX Plug
G579/12
10 Assembling and Dismantling
Operating position
When unplugged, the plug should be suspended, with the contact pins pointing
downward.
11 Installation
Electrical connection
The conductor must be carefully connected.
The conductor insulation must reach to the clamping points.
Do not damage the conductor (nicking) when removing the insulation.
Select suitable cables to be used and appropriate way of leading them to ensure that
the maximum permitted conductor temperature and the maximum permitted surface
temperature is not exceeded.
Protective conductor connection
A protective conductor is always required.
Connection
Loosen screws (A) and extract the plug insert manually from the enclosure.
Loosen clamp (C) and pressure screw (B).
Remove the dust protection plate, and take out the pressure ring and seal.
Push the cable (cable diameter max. 35 mm) through the pressure screw,
pressure ring, seal and enclosure.
If necessary, increase the internal diameter of the seal by trimming it to match the
cable diameter.
To protect the contact pins against pollution, a suitable protective cap should
be used (For R. STAHL order no. see "Spare parts and accessories").
09192T00
A =
Screw
B =
Pressure screw
C = Clamp
D = Strain relief
E =
Guiding groove
