Operating Instructions Scanner IDM
Maintenance, service
Page 30 of 36
R. STAHL HMI Systems GmbH / OI_Scanner_IDM_en_V_01_00_04.docx / 29.01.2016
12 Maintenance, service
Associated equipment is subject to maintenance, service and testing according to guidelines
1999/92/EC, IEC 60079-19, IEC/EN 60079-17 and BetrSichVer (Betriebssicherheitsverordnung
- Occupational Safety and Health) !
The units contain no replaceable parts. It is therefore not necessary to carry out regular
adjustments.
Maintenance should focus on the following:
•
Seal wear
•
Housing damage
•
All cables and lines are properly connected and undamaged
12.1 Servicing
It is the responsibility of the operator of an electrical plant in a hazardous environment to have
the plant serviced. Please also note the relevant national rules and regulations.
13 Troubleshooting
Users cannot carry out any repairs on the modules.
Devices operated in hazardous areas must not be modified. Repairs
may only be carried out by qualified, authorized staff specially trained
for this purpose.
Repairs may only be carried out by specially trained staff who are
familiar with all basic conditions of the applicable user regulations
and – if requested – have been authorized by the manufacturer.
14 Disposal
Disposal of packaging and used parts is subject to regulations valid in whichever country the
device has been installed.
The disposal of devices sold after August 13th, 2005, and installed in countries under the
jurisdiction of the EU is governed by directive (amendment) 2012/19/EU on waste electrical and
electronic equipment (WEEE). Under this directive, the scanners are listed in category 3 (IT-
and telecommunication equipment).
We shall take back our devices according to our General Terms and Conditions.
14.1 ROHS directive 2011/65/EC
The revised version of the ROHS (restriction of hazardous substances) 2002/95/EC directive,
directive 2011/65/EC, extends its area of application to all electric and electronic products.
In the case of scanners (category 3 - IT- and telecommunication equipment) a transitional
period applies until 22.07.2017, after which the banned substances listed in ROHS 2011/65/EC
directive apply to all devices newly put on the market.
NOTICE
Summary of Contents for IDM160
Page 35: ......
