Mounting and Installation
14
201521 / 9477605310
2018-08-13·BA00·III·en·06
Digital Output Module Relay Ex nA Outputs,
8 Channels for Zone 2 / Div. 2
Series 9477/15
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
8.1
Dimensions / Fastening Dimensions
8.2
Mounting / Dismounting, Operating Position
8.2.1 Mounting / Dismounting on BusRail
Mounting on BusRail
Dimensional drawings (All dimensions in mm [inches]) – Subject to alterations
09879E00
9477/15
NOTICE
Malfunction or device damage caused by improper mounting.
Non-compliance may lead to material damage!
• Only install and operate the device in a vertical or horizontal position!
(Horizontal orientation: Reading direction from below)
05683E00
• Position the module vertically at the
intended slot of the BusRail and
press lightly to snap it into place.
The module should not come loose
unless the handle is pressed.
• Plug the pluggable terminal X1 into
the module and secure it against
loosening using safety screws
(tightening torque 0.5 to 0.6 Nm).
• If necessary, mount a partition to
ensure a distance of at least 50 mm
between the intrinsically safe and
non-intrinsically safe electrical circuits.
67 mm / 2.64 "
96,5 mm / 3.8 "
128 mm / 5.04 "
BusRail
BusRail
Summary of Contents for IS1+ 9477/15 Series
Page 41: ......
