Page 52
7.
Rotate the drive sprockets (see Figure 19). Each sprocket should lock
in one direction and rotate freely in the reverse direction. Inspect the
drive shaft for wear when replacing a failed clutch sprocket.
8.
Check the pedal shafts and bushings by removing the pedal (see
Figure 22). Inspect the shafts and bushings for signs of wear and
corrosion. Clean corrosion off the pedal shafts with fine steel wool
and replace any worn bushings before reassembling. DO NOT SAND
THE PEDAL SHAFT.
9.
Reinstall all parts, ensuring proper tension of the Poly-V pulley belts
and that the top edge of the heel link pivot assembly is parallel with
the floor (see Figure 25). Lubricate all chain assemblies.
10.
Contact our Customer Service Department at (800) 331-3578 for
assistance. International customers should contact their local
distributors.
TROUBLESHOOTING
Summary of Contents for FREERUNNER 5600
