Page 70
HANDLE KNOB ASSEMBLY
1.
Remove the handle assembly.
2.
Remove the shoulder washer from each side of the handle yoke (see
Figure 28).
3.
Pull the handle adjustment knob out and slide the yoke out of the
handle.
4.
Remove the knob. Do this by inserting a phillips screwdriver or small
shaft into the handle knob pin to prevent it from spinning while you
rotate the knob counterclockwise. Remove the o-ring from the knob pin.
5.
Remove the knob pin from the inside of the handle. Slide the spring
off the knob pin.
6.
Install the new handle knob assembly on the handle and align the
handle yoke groove with the knob pin. Ensure that the groove on the
yoke faces out, towards the console (see Figure 28).
7.
Slide the yoke into the handle and verify that the knob shaft locks into
each handle position.
HEEL LINK
1.
Remove the pedal (see Figure 24).
2.
Remove the snap ring from the heel link pivot assembly.
3.
Separate the heel link from the pivot assembly.
PARTS REMOVAL AND REPLACEMENT
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE PROTECTION WHEN REMOVING
SNAP RINGS.
WARNING
!
Summary of Contents for FREERUNNER 5600
