Page 71
4.
Install the new heel link and reinstall the pedal. Remember to
lubricate the pedal shaft with mineral oil before installing the pedal.
Heel Link Pivot Assembly
1.
Remove the pedal.
2.
Remove the safety panel and side cover.
3.
Remove the heel link flange bearing and unhook the extension
spring.
4.
Remove the jam nut and washer from the pivot assembly shaft (see
Figure 23).
5.
Remove the heel link sprocket, with the chain attached, from the pivot
assembly shaft.
6.
Pull the pivot assembly out from the heel link bearing block.
7.
Install the new pivot assembly, and ensure that the pivot shaft key is
fully inserted into the key way. Reassemble the machine in reverse
order.
8.
Adjust the top edge of the heel link pivot assembly so that it is
horizontal with the floor (see Figure 27).
LEG ASSEMBLY
1.
Remove the pedal assembly.
2.
Remove the side cover.
3.
Remove the spring from the spring hanger, and loosen the drive chain
assembly turnbuckle (see Figure 19).
4.
Loosen the leg sprocket set screws (see Figure 20).
PARTS REMOVAL AND REPLACEMENT
Summary of Contents for FREERUNNER 5600
