Page 74
6.
Slide the pedal assembly off the pedal shafts and remove the
remaining washers.
7.
Install the new pedal assembly in reverse order.
PEDAL RETURN SPRINGS
1.
Remove the appropriate side cover.
2.
Reach between the alternator and the main frame (left side only) to
pull up on the spring and remove it from the spring hanger.
Note: If you are having difficulty removing the left spring,
remove the power control board for more accessibility.
3.
Detach the spring from the step chain by removing the single pitch
master link.
4.
Reinstall the spring and verify that it is seated in the spring hanger
groove.
POWER CONTROL BOARD
1.
Remove the left side cover.
2.
Unplug the lower brake cable, alternator cable, lower main cable,
stride sensor cable, load resistor cable, brake motor cable, and power
connector from the power control board (see Figure 30).
3.
Remove the two mounting screws from the board, and set the board
aside.
PARTS REMOVAL AND REPLACEMENT
DO NOT TWIST THE SPRING DURING INSTALLATION. IT WILL WEAR
EXCESSIVELY AND REDUCE THE LIFE OF THE SPRING.
WARNING
!
Summary of Contents for FREERUNNER 5600
