Page 79
2.
Remove the lower Poly-V belt, and remove the snap ring, washers,
and lower Poly-V pulley from the drive shaft.
3.
Remove the spring from the spring hanger, and disengage the pedal
arm spring chain from the sprocket.
4.
Remove the snap ring and washers from the drive shaft (right side
only).
5.
Rotate the sprocket off the drive shaft.
6.
Install the right sprocket with the teeth facing the mounting block and
the left sprocket with the teeth facing the side cover (see Figure 21).
7.
Reattach the spring and and verify that it is seated in the spring hangar
groove. Reinstall the side cover.
Upper Heel Link Idler Sprockets
1.
Remove the appropriate pedal, side cover, and safety panel.
2.
Remove the power control board (left side only).
3.
Loosen the heel link turnbuckle (see Figures 17 and 18), and remove
the heel link flange bearing.
PARTS REMOVAL AND REPLACEMENT
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE PROTECTION WHEN REMOVING
SNAP RINGS.
WARNING
!
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE PROTECTION WHEN REMOVING
SNAP RINGS.
WARNING
!
Summary of Contents for FREERUNNER 5600
