Assembly Manual
5
Before You Start
Locate the area where you will assemble and use your StairMaster
®
Commercial Series SC
916 StairClimber. We
recommend you install it on a hard, level surface. Allow an assembly area of at least 36” (0.91 m) on each side and
behind the machine. You can put the rear of the machine closer to the wall during use.
Basic Assembly
Follow these basic assembly tips when putting together your machine:
1. Collect all the pieces needed for each step before assembling.
2. Read through and understand the instructions before assembly.
3. Use a combination wrench when tightening a locknut on a bolt. Put the locknut tightly in the wrench and
make sure it connects all the way.
4. Turn all bolts and locknuts to the right to tighten, and the left to loosen.
5. Lightly and carefully lift pieces when attaching. Look through the bolt holes to help guide bolts through
the holes.
6. Two people are recommended to assemble this machine.
