Assembly Manual
9
Assembly
Step 6: Removing Console
Tools
• Phillips screwdriver
6-1
Remove the 4 Phillips screws attaching the SC916
Console to the upper mast weldment previously
placed to the side in Step 3 (see Figures
9 and 10).
6-2
Remove CHR and J6 Polar HR cables from the
back of the console connected to the PC board (see
Figure 11).
NOTE:
After removing the 2 cables from the PC board,
secure the cables to the console plate to keep the
cables from falling into the mast.
6-3
Set the console and the 4 screws to the side.
Figure 9
Figure 10
Figure 11
20 Pin Connector
J6 Polar HR
Contact Heart Rate (CHR)