Press
[FUNC]
repeatedly until the display shows
. Now you can adjust the number of the
first DMX channel (DMX address) used by the unit. Select a value between 1 and 505 using the
[UP]
and
[DOWN]
buttons. Press
[ENTER]
to store the value and to start operation in DMX mode.
Make sure that this number corresponds with the configuration of your DMX controller.
Press
[FUNC]
repeatedly until the display shows
. In this operation mode the unit follows
exactly the master device that it is connected to. Press
[ENTER]
to confirm and to start opera‐
tion in ‘Master/Slave’ mode.
Press
[FUNC]
repeatedly until the display shows
. Press
[ENTER]
to confirm and to start
operation in ‘Remote Control’ mode.
In this operating mode you can control the unit comfortably by remote. Take care that the
infrared sensor on the front panel of the device is not obstructed.
Operation mode ‘DMX’
Operation mode ‘Master/Slave’
Operation mode ‘Remote Con‐
trol’
Operation
DJ Lase 150-R MK-III
39
Summary of Contents for DJ Lase 150-R MK-III
