11
8. Press the button PROGRAM for three second, to exit Program mode, the LED goes
out indicating this selection.
Hint:
If you select different scenes at step 3 and 6, the editing scene would cover the scene at step 6.
4.5 Copy a Scene
1. Enter Program mode.
2. Press the button BANK, to turn on its fader control, which is indicated by the lit LED.
Use Jog wheel #1 to select the bank number to edit the scene.
3. Press the number button 1-20 to open the scene you are going to copy.
4. Press MANUAL/REC to store, LEDs on CUE, OVERRIDE, CENTRE, FIXTURE
GROUP, PRESET, CHASE, BANK, BLACKOUT blink at the same time.
5. Press BANK Then use the Jog wheel #1 to select the BANK number to copy the
scene.
6. Press the number button1-20, then copy the Scene to the right position. All LEDs
and the Segment Display will blink for three times briefly indicating this operation,
then the LCD will show the bank and the scene number of the programmed scene.
7. If you don‘t intend to continue your programming, press and hold down the
PROGRAM button for three seconds to exit Program mode, the LED goes out
indicating this selection.