Switching On/Off
To
switch on
the machine, press the on/off switch
8
. To lock on, press the on/off
switch
8
and lock by pressing the locking button
7
.
To
switch off
, release the on/off switch
8
. When locked, rst press the on/off switch
8
and then release.
Setting the Speed
By increasing or decreasing the pressure on the on/off switch
8
, the speed of the
switched-on machine can be continuously regulated.
Reduced speed of the machine facilitates the starting of holes (e.g., on smooth
surfaces such as tiles), pre¬vents the slipping of the drill and the splintering of the
drilled hole.
Recommended Speed Ranges:
- High speed for hammer drilling in concrete or stone as well as for chiseling
- Medium speed for drilling in steel and wood
- Low speed for driving screws and cutting threads.
Working Instructions
Chiseling
The SDS-plus tool can be turned in the tool holder to various positions to achieve an
optimum and low-fa- tigue working position.
Turn the operating mode selection switch
10
to position (Vario-Lock). Then turn
the tool in the tool holder to the desired position.
For chiseling, turn the operating mode selection switch
10
to position .
This locks the tool.
MAINTENANCE
Our power tools are constantly being Improved and modied to Incorporate the latest
technological advancements.
Accordingly, some parts (I.e. code numbers and/ or design) may be changed without
prior notice.
NOTE
Due to our’s continuing program of reserch and development, the specications herein
are subject to change without prior notice.8
PL
EN
21
ORIGINAL INSTR
UCTION
Summary of Contents for S-97155
