- 19 -
EN
•
electrical grid.
•
The appliance should be connected to a 400V 50Hz three-phase socket equipped with a circuit breaker
In=30mA by means of a plug or directly to the power supply.
To connect the device to an electrical equalizing system:
•
loosen the nut on the screw
•
enter the equipotential conductor
•
tighten the nut all the way
•
connect the other end of the equipotential cord to the equalizer.
Figure 7. Connecting the unit to an electrical equalizing system
6.
DEVICE OPERATION
Before turning the unit on, make sure that it is properly installed and that its technical condition
is safe for use.
•
Prior to operation, the control knob (Fig.8 pos. 1) should be set to “OFF”.
•
Place the utensil in the designated heating zone on the glass-ceramic hob.
•
Turn the knob clockwise and set the target power (“MIN” position - value 1, minimum power of the
device, “MAX” position - value 9, maximum). The set power is shown continuously on the display
(Fig.8 pos. 2) of the given heating zone located on the glass-ceramic hob. The lamp signalling heating -
generator work - will light up (Fig. 8 pos. 3).
•
In the absence of an utensil, the level of the set power will be displayed intermittently.
•
If you remove the utensil during operation, the generator stops (the signal lamp goes out, the value
of the set power is displayed intermittently); once it has been reset, it restarts its work immediately,
supplying the previously set power (the lamp lights up and the power level is displayed continuously).
•
To switch off the cooker, set the knob to “OFF” counterclockwise.
•
Do not disconnect the appliance from the main power immediately after finishing the work, because
the fans are still working to cool the hob to a safe temperature (removal of residual heat).
Residual heat
•
During operation, heat is transferred to the glass-ceramic hob. After finishing work and setting the knob
in the “OFF” position, the letter “H” will appear on the display (Fig. 8 pos. 2), meaning that the glass
is hot and should not be touched, as it may cause burns. This symbol is displayed until the fans have
cooled the hob to a safe level.
1.
Control knob
2.
Power level and error code display
3.
Signaling active heating process
(generator running)
4.
Error signaling
Figure 8. Device controls
