- 5 -
5. OPERATION
5.1. Start-up
Before first use, activate the empty device for about 10 minutes in order to burn out the oil and thermal insulation residue,
which may cause an unpleasant smell. After completing this step, it is necessary to thoroughly clean the device and its
components using a damp cloth with a non-abrasive cleaning agent.
5.2. Operation of a toaster with ceramic heating elements and a switch
In order to start the device turn the timer to the appropriate time. The maximum available time is 15 minutes. Switch the
upper switch in order to activate the upper heating elements and the bottom switch in order to activate the bottom heating
elements. The central heating elements are only controlled using the timer. After the expiry of the selected time the heating
elements will turn off automatically.
6. CLEANING AND MAINTENANCE
During the cleaning and maintenance of the device, make sure that it is disconnected from the source of power supply in order
to prevent accidents.
Frequent emptying of the crumbs tray is recommended.
The surfaces of the toaster should be cleaned using a soft cloth, without any caustic cleaning agents.
The On/Off switches may only be cleaned with a dry cloth. It is prohibited to wash the device, including the housing, using a
stream of water, as this could cause the water to get inside the device and damage it.
7. DISPOSING OF USED EQUIPMENT
You can return your old device after the end of use or when buying a new device at Stalgast. Send the device to us and a
specialized company will dispose of it in accordance with the Waste Electrical and Electronic Equipment Act (Journal of Laws
of 2005, No. 180, item 1495).
8. WARRANTY
The seller shall be liable under the warranty or guarantee.
In the event of damages resulting from the formation of limescale deposits in the device, they are not subject to repair under
warranty. The warranty does not cover damages caused by external forces such as lightning, changes in supply voltage,
incorrect setting of the voltage value, supply from an inadequate power outlet, mechanical, thermal, chemical damages to the
equipment and the defects caused by them
Warranty exchange does not cover such elements as: light bulbs, rubber components, heating elements damaged by limescale,
screws and elements undergoing natural wear, e.g. burners, rubber seals and all kinds of mechanically damaged elements.
