STEP 1:
Insert the
FRONT STABILIZER(2)
into the
MAIN FRAME(1)
and lock in position with the
LOCKING KNOB(31).
NOTE:
STEP 2
NOTE:
Thread the
RIGHT PEDAL(6)
onto the right side of the
CRANK(7)
as shown. Tighten the pedal securely.
Do the same to attach the
LEFT PEDAL(5)
onto the left side of the
CRANK(7).
STEP 3:
Install two
"
AA
"
batteries into the back of the
METER(29).
Plug the
SENSOR WIRE(28)
to
the
METER(29),
then slide the
METER(29)
onto the Bracket on the
MAIN FRAME(1).
ASSEMBLY INSTRUCTIONS
6
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance
1 (800) 375-7520
or e-mail us at:
parts@staminaproducts.com
The
RIGHT PEDAL(6)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(6)
has right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(5)
has
L
stamped
on the end of the pedal shaft. The
LEFT PEDAL(5)
has left hand threads and is tightened by
turning counter clockwise.
RIGHT
BRACKET
Pull the
FRONT STABILIZER(2)
out for use. Push the
FRONT STABILIZER(2)
in for storage.
Adjust the
FRONT STABILIZER(2)
by loosening the
LOCKING KNOB(31),
then slide the
FRONT STABILIZER(2)
to adjust the position. Tighten the
LOCKING KNOB(31).
LEFT
