TENSION BELT ADJUSTMENT
Should the tension system not fulfill your needs it can be
readjusted following this procedure:
Turn the
TENSION KNOB(26)
to the loosest setting (counter-clockwise).
Lift the tab on the
BUCKLE(23)
to release the grip on the
TENSION BELT(24).
If the tension is too loose, tighten the
TENSION BELT(24)
1/4" and reset the
BUCKLE(23).
If the tension is too tight, loosen the
TENSION BELT(24)
1/4" and reset the
BUCKLE(23).
Pedal to test the tension. If it is still not adequate continue to adjust the
TENSION BELT(24)
1/4" at a
time until it is right for you.
1.
2.
3.
4.
Upper Body:
Place the bike on a table or desk. Grasp the pedals
firmly with your hands and pedal the bike. This exercise can be
performed while seated or standing.
8
Lower Body:
Place the bike on the floor in front of a chair. Sit in
the chair and pedal the bike with your feet.
Caution:
Do not stand up on the
hi-lo Cycle 100.
EXERCISE WORKOUT
OPERATIONAL INSTRUCTIONS
FRONT STABILIZER ADJUSTMENT
Pull the
FRONT STABILIZER(2)
out for use. Push the
FRONT STABILIZER(2)
in for storage. Adjust the
FRONT STABILIZER(2)
by loosening the
LOCKING
KNOB(31),
then slide the
FRONT STABILIZER(2)
to
adjust the position. Tighten the
LOCKING KNOB(31).
LOAD ADJUSTMENT
To increase the load, turn the
TENSION KNOB(26)
clockwise. To decrease the load, turn the
TENSION
KNOB(26)
counterclockwise.
