ASSEMBLY INSTRUCTIONS
9
STEP 8
NOTE:
The
RIGHT PEDAL(32)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(32)
has
right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(31)
has
L
stamped on the end
of the pedal shaft. The
LEFT PEDAL(31)
has left hand threads and is tightened by turning counterclockwise.
Thread the
RIGHT PEDAL(32)
to the
RIGHT CRANK(34)
as shown. Tighten the pedal securely. Refer to
the detail view below. The shoulder of the
PEDALS(31, 32)
should be in contact with the
CRANKS(33, 34)
when securely tightened.
Repeat on the left side in order to attach the
LEFT PEDAL(31)
to the
LEFT CRANK(33).
STEP 9
Install two AAA batteries into the
METER(14),
the batteries are not included. See page 11 for detailed battery
installation instructions. Plug the
SENSOR WIRE(82)
into the connecting wire on the
METER(14),
and push
the excess wires back into the
MAIN FRAME(1).
Slide the
METER(14)
onto the
METER BRACKET(8).
NOTE:
Be careful not to damage the wires when attaching the
METER(14).
Shoulder
Shoulder
Shoulder
Summary of Contents for 15-0199
Page 3: ......
Page 16: ...PRODUCT PARTS DRAWING 16 FRONT BACK...
Page 20: ...NOTES 20...
Page 21: ...NOTES 21...
