ADJUSTMENT INSTRUCTIONS
Chain Adjustment
Chain Adjustment required if the Chain is too loose.
Loosen the
NUTS(3/8"-26)(66)
on both sides of the fan.
Adjust the
NUT(M6x1)(65)
on the chain side of bike to remove
all slack from the chain.
Adjust the
NUT(M6x1)(65)
on the side opposite the chain so
that the center of the
NUT(3/8"-26)(66)
is the same distance
from
TAB
on both sides of bike.
Tighten the
NUTS(3/8"-26)(66)
on both sides of the fan.
1.
2.
3.
4.
TAB
15
Fan Adjustment
Fan Adjustment is required if the fan locks up or the resistance of the fan increases after use. To
adjust the fan, use the following procedures:
It is best to lift the front of the frame and remove the fan and fan cages thru the bottom of
the bike.
Remove both
PEDALS(31, 32).
Remove the
SCREWS(52, 54, and 55)
holding the
CHAIN GUARDS(29, 30)
and
FAN CAGES(28)
to the
BIKE.
Remove the
CHAIN GUARDS(29, 30).
NOTE:
The
CRANK(10)
should be pointing down.
Remove the
NUTS(3/8"-26)(66), EYE BOLTS(22),
and
NUT(M6x1)(65)
from the
FAN AXLE(21).
Slide the
FAN(18)
toward the rear and slide the
CHAIN(17)
off of the big sprocket on the
CRANK(10).
Then slide the
CHAIN(17)
off of the small sprocket on the
FAN(18).
Unhook the
TENSION STRAP(25)
from the
FRAME(1).
Remove the
FAN(18)
and
FAN CAGES
(28)
from the bike.
HINT
:
STEP 1:
STEP 2:
STEP 3:
STEP 4:
STEP 5:
Left Side View
Small Sprocket
