OPERATIONAL INSTRUCTIONS
The meter will shut off automatically after four minutes of inactivity. All function values will be kept.
Press the
RESET
button and hold it down for four seconds to reset all functions to zero.
NOTE:
POWER OFF:
Pedal movement or press the
MODE
button.
Automatic shut off after four minutes of inactivity.
POWER ON:
USING THE FITNESS METER
FUNCTIONS:
SCAN:
TIME:
SPEED:
DISTANCE:
CALORIE:
15
PRESET VALUES OPERATION:
Stop pedaling for four seconds. When
“STOP”
appears on display the meter is in setting mode. The meter will cycle
through the functions as follows and allow you to set the function values.
Time (0:00 to 99:00)
Distance (0.0 to 99.99 mile)
Calorie (0.0 to 999.9 Kcal)
Use
SET
and
RESET
buttons to choose desired setting values, and press
MODE
button to confirm. Or, just press
the
MODE
button to skip the setting and move on to the next function. After all the desired settings are chosen, begin
pedaling to start the workout.
FUNCTION BUTTONS:
RESET :
This button will reset each function to zero.
To reset all functions to zero, press the button and
hold it down for four seconds.
MODE :
Press and release to select functions for display or
to preset target values.
SET :
Press to set target values for TIME, DISTANCE ,
and CALORIE.
AA Batteries
HOW TO INSTALL AND REPLACE BATTERIES:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with another
type of battery.
3. Rechargeable batteries are not recommended.
NOTE:
Automatically scans
TIME, SPEED, DISTANCE,
and
CALORIE
in sequence with a change every
four seconds. Press and release the
MODE
button until
“SCAN”
appears on display.
Press
MODE
button until “TMR” appears to display the time from one second up to 99:59 minutes.
Counts down from preset value.
Press
MODE
button until “SPD” appears to display the current speed from zero to 999.9 miles per
hour.
Press
MODE
button until “DST” appears to display the distance from zero to 99.99 miles. Counts
down from preset value.
Press
MODE
button until “CAL” appears to display the calorie consumption from zero to 999.9 Kcal.
Counts down from preset value.
The calorie readout is an estimate for an average user. It should be used only as a comparison
between workouts on this unit.
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AA batteries, the batteries are not
included. Refer to the illustration to install or replace the batteries.
SPEED INDICATOR:
When pedaling, the LCD will display a bar to show the approximate
current speed.
MODE
