ASSEMBLY INSTRUCTIONS
7
STEP 4
NOTE:
Install the
HEX BOLTS(63)
as shown in the illustration above. This allows the head of the bolts to
fit inside the hex shape holes in the
SEAT FRAMES(5, 6).
Attach the
RIGHT HANDRAIL(8)
to the
RIGHT SEAT FRAME(6)
with
HEX BOLTS(M6x1x35mm)(63),
ARC WASHERS(M6)(78), LOCK WASHERS(M6)(80),
and
ACORN NUTS(M6x1)(73).
Repeat on the left
side.
STEP 5
Plug the
LEFT
and
RIGHT PULSE SENSOR WIRES(34,35)
into the
REAR EXTENSION WIRE(33)
located
on the
REAR FRAME(3).
Push the plugs and any excess wire back into the opening in the
REAR FRAME(3).
Refer to the Bottom View illustration. Position the
SQUARE PLUG(50)
with its arc indentation facing toward
the front of the bike so the wires feed out of the frame toward the front. Please note that the slot is bigger
than the
SQUARE PLUG(50)
to allow room for the wires.
BOTTOM VIEW
Make the arc indentation
face to the front.
