ASSEMBLY INSTRUCTIONS
STEP 7
NOTE:
The
RIGHT PEDAL(43)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(43)
has
right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(42)
has
L
stamped on
the end of the pedal shaft. The
LEFT PEDAL(42)
has left hand threads and is tightened by turning
counter clockwise.
Thread the
RIGHT PEDAL(43)
onto the right side of the
CRANK(9)
as shown. Tighten the pedal securely.
Do the same to attach the
LEFT PEDAL(42)
onto the left side of the
CRANK(9).
STEP 8
Install four
AA
batteries into the
METER(30),
four batteries included. See page 11 for detailed battery
installation instructions. Run the Extension Wire on the
METER(30)
through the
METER POST(28).
Attach
the
METER(30)
onto the
METER POST(28)
with
ROUND HEAD SCREWS(M5x0.8x10mm)(64).
STEP 9
Plug the
MOTOR CONTROL WIRE(29)
and
FRONT EXTENSION WIRE(32)
to the Extension Wire on the
METER(30).
Insert the
METER POST(28)
onto the
FRONT FRAME(1)
and secure with
ROUND HEAD
BOLTS(M6x1x15mm)(59), LOCK WASHERS(M6)(80),
and
ARC WASHERS(M6)(78).
NOTE:
Be careful not to damage the wires when attaching the
METER(30).
9
