14
HOW TO INSTALL AND REPLACE BATTERY:
AA Batteries
COMPUTER INSTRUCTIONS
1.
2.
Do not mix a new battery with an old battery.
Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
Rechargeable batteries are not recommended.
1.
2.
3.
NOTE:
Open the Battery Door on the back of the meter.
The meter operates with two AA batteries, two batteries included.
Refer to the illustration to install or replace the batteries.
OPERATION DESCRIPTIONS
To stop a running program, stop pedaling for 4 seconds to switch into
"STOP"
mode. In this mode, you
can move the pedals again to continue to run the current program or, you can press the
SET
button to
select a new program. The functional values of
DISTANCE
and
CALORIES
will continue to accumulate.
When you complete a program, you can stop pedaling and press
SET
button to select a new program.
The functional values of
DISTANCE
and
CALORIES
will continue to accumulate. This will allow you to
run several programs and still know the total
DISTANCE
and
CALORIES
during the workout.
If you want to restart with a new program, press and hold the
MODE
button down for two seconds to
reset all of the function values to zero. Press
SET
button to select a new program.
The computer will shut off automatically after 3 minutes of inactivity and all function values will be reset
to zero.
1.
2.
3.
4.
STORAGE
1.
2.
3.
4.
To store the
4800R Recumbent Bike
simply keep it in a clean dry place.
Adjust the
REAR FRAME(3)
into the
FRONT FRAME(1)
to the shortest position. The
4800R Recumbent
Bike
is approximately 45 5/8" long x 28" wide x 33" tall. These dimensions will vary. Please measure
your
4800R Recumbent Bike
if exact dimensions are needed.
To move the
4800 Recumbent Bike,
lift the
REAR STABILIZER(4)
and use the
WHEELS(48)
on the
FRONT STABILIZER(2).
To avoid damage to the electronics, remove the batteries before storing the
4800R Recumbent Bike
for
one year or more.
MAINTENANCE
The safety and integrity designed into the
4800R Recumbent Bike
can only be maintained when the
4800R Recumbent Bike
is regularly examined for damage and wear. Special attention should be given to
the following:
Adjust the
TENSION KNOB(24)
and verify that the Magnetic System provides tension. The Magnetic
System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise.
Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the
4800R Recumbent Bike
removed
from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the
4800R Recumbent
Bike.
Keep your
4800R Recumbent Bike
clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
Summary of Contents for 15-4800R
Page 18: ...PRODUCT PARTS DRAWING 18 FRONT BACK...
Page 21: ...21 NOTES...
