Stamina 15-4800R, Owner'S Manual

ASSEMBLY INSTRUCTIONS

STEP 7:  

Identify the 

POST CAP(82) 

on the 

FRONT FRAME(1).

  Run the 

SENSON WIRE(27)

 and

the 

PULSE PLUG WIRE(36)

 through the 

COMPUTER POST(81).

  Then insert the 

COMPUTER

POST(81)

 into the 

FRONT FRAME(1)

 and secure with 

BOLT(M6 x 15mm)(83).

8

STEP 8:  

Install two 

"AA"

 batteries into the 

COMPUTER(26),

 two batteries included.  See page 14 for

detailed battery installation instructions.  Plug the 

SENSOR WIRE(27)

 into the wire on the 

COMPUTER(26)

and plug the 

PULSE PLUG WIRE(36) 

into the back of the 

COMPUTER(26).

  Push the excess wires

back into the 

COMPUTER POST(25), 

then slide the 

COMPUTER(26)

onto the 

COMPUTER POST(25).

NOTE:

  Be careful not to damage the wires when attaching the 

COMPUTER(26).

STEP 6
NOTE:

Thread the 

RIGHT PEDAL(34)

 onto the right side of the 

CRANK(7)

 as shown.  Tighten the pedal securely.

Select the 

RIGHT PEDAL STRAP(80)

 which has 

R

 marked on the bottom side of the strap.  Snap the two

hole end onto the inside edge of the 

RIGHT PEDAL(34).

  Snap the other end onto the outside edge of the

RIGHT PEDAL(34)

 with the 

R

 mark on the bottom of the 

RIGHT PEDAL STRAP(80).

  Select adjustment

holes which allow your foot to be easily removed from the pedals.
Use the same procedure to attach the 

LEFT PEDAL(33)

 onto the left side of the 

CRANK(7)

 and snap the

LEFT PEDAL STRAP(79)

 onto the 

LEFT PEDAL(33).

The 

RIGHT PEDAL(34)

 has 

R

 stamped on the end of the pedal shaft.  The 

RIGHT PEDAL(34)

has right hand threads and is tightened by turning clockwise.  The 

LEFT PEDAL(33)

 has 

L

stamped on the end of the pedal shaft.  The 

LEFT PEDAL(33)

 has left hand threads and is

tightened by turning counter clockwise.