Stamina 15-4825, Owner'S Manual

15

COMPUTER INSTRUCTIONS

STORAGE

1.
2.

3.

4.

To store the 

Magnetic Recumbent 4825 Bike,

 simply keep it in a clean dry place.

Adjust the 

REAR FRAME(3)

 and 

FRONT FRAME(1)

 to the shortest position. The 

Magnetic Recumbent

4825 Bike

 is approximately 42 3/8 inches long x 26 3/4 inches wide x 31 3/4 inches tall. These dimensions

will vary. Please measure your 

Magnetic Recumbent 4825 Bike

 if exact dimensions are needed.

To move the 

Magnetic Recumbent 4825 Bike,

 lift the 

REAR STABILIZER(4)

 and use the 

WHEELS(49)

on the 

FRONT STABILIZER(2).

To avoid damage to the electronics, remove the batteries before storing the 

Magnetic Recumbent 4825

Bike

 for one year or more.

MAINTENANCE

The safety and integrity designed into the 

Magnetic Recumbent 4825 Bike

 can only be maintained when

the 

Magnetic Recumbent 4825 Bike

 is regularly examined for damage and wear. Special attention should

be given to the following:

Adjust the 

TENSION KNOB(25)

 and verify that the Magnetic System provides tension. The Magnetic

System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise.
Verify that the 

WARNING LABEL(78)

 is in place and easy to read. Call Stamina Products immediately at

1-800-375-7520 for a replacement 

WARNING LABEL(78)

 if it is missing or damaged.

It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the 

Magnetic Recumbent 4825 Bike

removed from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the 

Magnetic Recumbent

4825 Bike.

Keep your 

Magnetic Recumbent 4825 Bike

 clean by wiping with an absorbent cloth after use.

1.

2.

3.

4.
5.

6.

7.

HOW TO INSTALL AND REPLACE BATTERY:

AA Batteries

1.
2.

Do not mix a new battery with an old battery.
Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
Rechargeable batteries are not recommended.

1.
2.

3.

NOTE:

Open the Battery Door on the back of the computer.
The computer operates with two AA batteries. Two batteries are
included. Refer to the illustration to install or replace the batteries.

OPERATION DESCRIPTIONS

To stop a running program, stop pedaling for 4 seconds to switch into 

STOP

 mode. In this mode, you can

move the pedals again to continue to run the current program, or you can press the 

SET

 button to select

a new program. The function values of 

DISTANCE

 and 

CALORIES

 will continue to accumulate.

When you complete a program, you can stop pedaling and press 

SET

 button to select a new program.

The function values of 

DISTANCE

 and 

CALORIES

 will continue to accumulate. This will allow you to run

several programs and still know the total 

DISTANCE

 and 

CALORIES

 during the workout.

If you want to restart with a new program, press and hold the 

MODE

 button down for two seconds to reset

all of the function values to zero. Press 

SET

 button to select a new program.

The computer will shut off automatically after 3 minutes of inactivity, and the function values, 

DISTANCE

and 

CALORIES

, will be kept.

1.

2.

3.

4.