Stamina 15-4825B, Owner'S Manual

ASSEMBLY INSTRUCTIONS

STEP 7

Install two AA batteries into the 

COMPUTER(27).

 Two batteries are included. See page 15 for detailed

battery installation instructions. Refer to the inset drawing. Run the Connection Wires of the 

COMPUTER(27)

through the 

COMPUTER POST(26)

 from the square hole on the top of the 

COMPUTER POST(26)

 until the

Connection Wires extend out of the bottom end of the 

COMPUTER POST(26).

 Place the 

COMPUTER(27)

onto the plate on the 

COMPUTER POST(26)

 and secure with 

ROUND HEAD SCREWS(M5x0.8x15mm)(62).

STEP 8

Connect the 

SENSOR WIRE(28)

 and the 

PULSE PLUG WIRE(37)

 to the Connection Wires of the

COMPUTER(27),

 and push the excess wires back into the 

FRONT FRAME(1). 

Then insert the 

COMPUTER

POST(26)

 into the 

FRONT FRAME(1)

 and secure with 

BUTTON HEAD BOLT(M8x1.25x15mm)(57).

NOTE:

9

STEP 6

NOTE:

The 

RIGHT PEDAL(35)

 has 

R

 stamped on the end of the pedal shaft. The 

RIGHT PEDAL(35)

 has

right hand threads and is tightened by turning clockwise. The 

LEFT PEDAL(34)

 has 

L

 stamped on

the end of the pedal shaft. The 

LEFT PEDAL(34)

 has left hand threads and is tightened by turning

counterclockwise.

Thread the 

RIGHT PEDAL(35)

 to the right side of the 

CRANK(7)

 as shown. Tighten the pedal securely. Do

the same to attach the 

LEFT PEDAL(34)

 to the left side of the 

CRANK(7).

Be careful not to damage the wires when attaching the 

COMPUTER(27)

 and the 

COMPUTER

POST(26).