ASSEMBLY INSTRUCTIONS
8
STEP 3
NOTE:
The
RIGHT PEDAL(36)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(36)
has
right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(35)
has
L
stamped on
the end of the pedal shaft. The
LEFT PEDAL(35)
has left hand threads and is tightened by turning
counter clockwise.
STEP 4
Refer to the Illustration. Make the protrusion in the
POST BUSHING(42)
face to the front. Insert the
POST
BUSHING(42)
into the
MAIN FRAME(1).
Slide the
POST SLEEVE(33)
onto the
MAIN FRAME(1).
STEP 5
Attach the
SEAT(44)
to the
SEAT POST(6)
with
NYLOCK NUTS(M8x1.25)(60)
and
WASHERS(M8)(67).
Slide the
BELLOWS(41)
over the
SEAT POST(6).
Insert the
SEAT POST(6)
into the
MAIN FRAME(1)
and
secure with the
ADJUSTMENT KNOB(43).
NOTE:
The
ADJUSTMENT KNOB(43)
should be screwed in tight to make the
SEAT POST(6)
fit securely
in the
MAIN FRAME(1).
Thread the
RIGHT PEDAL(36)
to the right side of the
CRANK(7)
as shown. Tighten the pedal securely. Do
the same to attach the
LEFT PEDAL(35)
to the left side of the
CRANK(7).
The Protrusion
faces to the front.
