ASSEMBLY INSTRUCTIONS
STEP 6
Slide the
UPRIGHT SLEEVE(32)
over the
UPRIGHT(4).
Set the
TENSION KNOB(25)
on the
UPRIGHT(4)
at position
"8",
so the cable end extends out of the metal fitting as far as possible. Pull the ends of the
TENSION CABLE(24)
and
SENSOR WIRE(28)
out of the
MAIN FRAME(1).
Refer to the inset drawing.
Connect the
CABLE END
of the
TENSION KNOB(25)
into the
SPRING HOOK
on the end of the
TENSION
CABLE(24).
Pull on the Cable of the
TENSION KNOB(25)
firmly so that enough cable is available to insert
the cable through the slot in the
BRACKET.
Then insert the
METAL FITTING
on the cable of the
TENSION
KNOB(25)
into the hole at the end of the slot in the
BRACKET.
Adjust the
TENSION KNOB(25)
and verify
that the
SPRING HOOK
moves when the
TENSION KNOB(25)
is adjusted.
STEP 7
Connect the
CONNECTION WIRE(27)
to the
SENSOR WIRE(28).
Insert the
UPRIGHT(4)
onto the
MAIN
FRAME(1)
and secure with
BUTTON HEAD BOLTS(M8x1.25x20mm)(51), LOCK WASHERS(M8)(67),
and
ARC WASHERS(M8)(66).
Slide down the
UPRIGHT SLEEVE(32)
to cover the bolt heads.
9
CABLE END
SPRING HOOK
BRACKET
METAL FITTING
