16
OPERATIONAL INSTRUCTIONS
STORAGE
1.
2.
3.
4.
To store the
Stamina® Magnetic Upright Exercise Bike,
simply keep it in a clean dry place.
The
Stamina® Magnetic Upright Exercise Bike
is approximately 38 1/2 inches long x 22 inches wide x
52 inches tall. These dimensions will vary. Please measure your
Stamina® Magnetic Upright Exercise
Bike
if exact dimensions are needed.
Move the
Stamina® Magnetic Upright Exercise Bike
with the moving wheels on the
FRONT
STABILIZER(2).
Grasp on the
HANDLEBAR(5),
tip the
Stamina® Magnetic Upright Exercise Bike
forward and move slowly.
To avoid damage to the electronics, remove the batteries before storing the
Stamina® Magnetic Upright
Exercise Bike
for one year or more.
MAINTENANCE
The safety and integrity designed into the
Stamina® Magnetic Upright Exercise Bike
can only be
maintained when the
Stamina® Magnetic Upright Exercise Bike
is regularly examined for damage and
wear. Special attention should be given to the following:
Adjust the
TENSION KNOB(25)
and verify that it functions properly and the resistance changes.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the left
pedal has left hand threads and is tightened by turning counterclockwise.
Verify that the
WARNING LABEL(70)
is in place and easy to read. Call Stamina Products immediately at
1-800-375-7520 for a replacement
WARNING LABEL(70)
if it is missing or damaged.
Do not step on any portion of the plastic cover when getting on or off the Bike. This can cause the plastic
cover to crack.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components must be replaced immediately or the
Stamina® Magnetic Upright Exercise
Bike
removed from service until repair is made.
Only Stamina Products supplied components should be used to maintain/repair the
Stamina® Magnetic Upright
Exercise Bike.
Keep your
Stamina® Magnetic Upright Exercise Bike
clean by wiping it off with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
8.
HOW TO INSTALL AND REPLACE BATTERY:
AA Batteries
1.
2.
Open the Battery Door on the back of the computer.
The computer operates with two AA batteries, the batteries are not
included. Refer to the illustration to install or replace the batteries.
OPERATION DESCRIPTIONS
To stop a running program, stop pedaling for 4 seconds to switch into
STOP
mode. In this mode, you
can move the pedals again to continue to run the current program, or you can press the
SET
button to
select a new program. The function values of
DISTANCE
and
CALORIES
will continue to accumulate.
When you complete a program, you can stop pedaling and press
SET
button to select a new program.
The function values of
DISTANCE
and
CALORIES
will continue to accumulate. This will allow you to
run several programs and still know the total
DISTANCE
and
CALORIES
during the workout.
If you want to restart with a new program, press and hold the
MODE
button down for two seconds to
reset all of the function values to zero. Press
SET
button to select a new program.
The computer will shut off automatically after 3 minutes of inactivity and all function values will be reset
to zero.
1.
2.
3.
4.
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline
battery with another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled
according to all state and federal laws and regulations.
5. Do not dispose of batteries in fire.
NOTE: