Stamina 15-7100B, Owner'S Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers or the
ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.

NOTICE:

The length of all bolts and screws, except those with flat heads,
is measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.

mm.

in.

INCHES

MILLIMETERS

1

1/2

0

2

1/2

3

1/2

4

1/2

5

1/2

6

1/2

0

10

20

30

40

50

60

70

80

90

100

110 120

130 140 150

6

8

10

12

3/16"

5/16"

1/2"

3/8"

1/4"

length

length

After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.

6

Part No. and Description

Qty

91

Washer (M8)

   2

92

Washer (M10)

   1

62

Carriage Bolt (M8 x 1.25 x 45mm)

   2

63

Carriage Bolt (M8 x 1.25 x 75mm)

   2

64

Bolt, Button Head (M8 x 1.25 x 40mm)

   3

65

Bolt, Button Head (M8 x 1.25 x 53mm)

   2

66

Bolt, Button Head (M10 x 1.5 x 20mm)

   4

67

Bolt, Button Head (M10 x 1.5 x 53mm)

   2

68

Bolt, Hex Head (M8 x 1.25 x 80mm)

   1

69

Bolt, Flat Head (M6 x 1 x 12mm)

   2

73

Bolt, Round Head (M6 x 1 x 15mm)

   4

75

Screw, Round Head (M4 x 0.7 x 15mm)

   6

80

Nut (M8 x 1.25)

   1

84

Acorn Nut (M8 x 1.25)

   4

85

Acorn Nut (M10 x 1.5)

   1

86

Arc Washer (M8)

   4

87

Arc Washer (M10)

   4

88

Lock Washer (M8)

   6

89

Lock Washer (M10)

   6

70

Bolt, Flat Head (M8 x 1.25 x 15mm)

   6