Stamina 15-7200, Owner'S Manual

19

COMPUTER INSTRUCTIONS

POWER SOURCE:

The computer uses the 

ADAPTER(105)

 as a power source. Use the 

Magnetic Fusion 7200 Bike

 with the

adapter plugged into an electrical outlet.

STORAGE

1.
2.

3.

To store the 

Magnetic Fusion 7200 Bike,

 simply keep it in a clean dry place.

Adjust the 

SEAT FRAME(8)

 to the lowest position. The 

Magnetic Fusion 7200 Bike

 is approximately

53 1/4 inches long (min.) x 24 1/2 inches wide x 51 3/4 inches tall. These dimensions will vary. Please
measure your 

Magnetic Fusion 7200 Bike

 if exact dimensions are needed.

To move the 

Magnetic Fusion 7200 Bike,

 lift the 

REAR STABILIZER(6)

 and the bike will roll on the

WHEEL(62)

 on the 

FRONT STABILIZER(2).

MAINTENANCE

The safety and integrity designed into the 

Magnetic Fusion 7200 Bike

 can only be maintained when the

Magnetic Fusion 7200 Bike

 is regularly examined for damage and wear. Special attention should be given

to the following:

Use the 

UP

 and 

DOWN 

buttons on the 

COMPUTER(27)

 to select a program and verify that the Magnetic

System provides different tensions. The Magnetic System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise. The right pedal has right
hand threads that are tightened by turning clockwise.
Verify that the 

WARNING LABEL(109)

 is in place and easy to read. Call Stamina Products immediately

at 1-800-375-7520 for a replacement 

WARNING LABEL(109)

 if it is missing or damaged.

It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the 

Magnetic Fusion 7200 Bike

 removed

from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the 

Magnetic Fusion

7200 Bike.

Keep your 

Magnetic Fusion 7200 Bike

 clean by wiping it off with an absorbent cloth after use.

1.

2.

3.

4.
5.

6.

7.

OPERATION DESCRIPTIONS

To stop a running program, press the 

START

/

STOP

 button. In this mode, you can press the

START

/

STOP

 button again to continue to run the current program. Or, you can use 

" / "

 buttons to

select a new program. The function values of 

DISTANCE 

and 

CALORIE

 will continue to accumulate.

When you complete a program, press the 

START

/

STOP

 button to stop the program. You can use

" /

"

 buttons to select a new program. The function values of 

DISTANCE 

and 

CALORIE

 will continue

to accumulate. This will allow you to run several programs and still know the total 

DISTANCE 

and 

CALORIE

during the workout.
If you want to restart with a new program, press the 

RESET

 button to reset all of the function values to

zero. Use 

"

/ "

 buttons to select a new program.

The computer will shut off automatically after 4 minutes of inactivity, and the function values, 

DISTANCE

and 

CALORIE

, will be kept.

1.

2.

3.

4.

NOTE:

Batteries are not required in the compartment on the back of the 

COMPUTER(27)

 of the 

Magnetic

Fusion 7200 Bike.