Stamina 15-9100, Owner'S Manual

ASSEMBLY INSTRUCTIONS

7

Allen Wrench

STEP 4

NOTE:

Thread the 

RIGHT PEDAL(27)

 onto the 

RIGHT CRANK(58)

 located inside the 

CRANK COVER(22)

as shown.  Tighten the pedal securely.  Select the 

RIGHT PEDAL STRAP(28)

 which has 

R

 marked on

the bottom side of the strap.  Snap the three hole end onto the inside edge of the 

RIGHT PEDAL(27).

Snap the other end onto the outside edge of the 

RIGHT PEDAL(27)

 with the 

R

 mark on the bottom of the

RIGHT PEDAL STRAP(28).

  Select adjustment holes which allow your foot to be easily removed from

the pedals.  Use the same procedure to attach the 

LEFT PEDAL(25)

 onto the 

LEFT CRANK(57)

 and

snap the 

LEFT PEDAL STRAP(26)

 onto the 

LEFT PEDAL(25).

The 

RIGHT PEDAL(27)

 has 

R

 stamped on the end of the pedal shaft.  The 

RIGHT PEDAL(27)

has right hand threads and is tightened by turning clockwise.  The 

LEFT PEDAL(25)

 has 

L

 stamped

on the end of the pedal shaft.  The 

LEFT PEDAL(25)

 has left hand threads and is tightened by

turning counter clockwise.

STEP 6:  

Insert the 

SEAT POST(3)

 into the 

REAR FRAME(2)

 and secure with the 

SPRING KNOB(64).

NOTE:

The 

SPRING KNOB(64)

 should be screwed in tight to make the 

SEAT POST(3)

 fit securely in

the 

REAR FRAME(2).

STEP 5:  

Refer to the inset drawing.  Insert the 

ADJUSTMENT BLOCK(38)

 into the 

SEAT POST(3).

Insert the 

SEAT ADJUSTMENT LEVER(63)

 through the 

SEAT POST(3)

 and 

ADJUSTMENT

BLOCK(38)

 and secure by tightening the set screws inside the 

ADJUSTMENT BLOCK(38)

 with Allen

Wrench.