Stamina 15-9300, Owner'S Manual

1.  To store the 

CPS 9300 Indoor Cycle,

 simply keep it in a clean dry place.

2.  Adjust the 

HANDLEBAR(2)

 and the 

SEAT POST(5)

 to the lowest position. Adjust the 

SEAT SLIDER(6)

to the most forward position. The 

CPS 9300 Indoor Cycle

 is approximately 41.8 inches long (min.) x 

18.4 inches wide x 38.3 inches tall (min.). These dimensions will vary. Please measure your 

CPS 9300 

Indoor Cycle

 if exact dimensions are needed.

3.  To move the 

CPS 9300 Indoor Cycle,

 lift the 

REAR STABILIZER(4)

 and use the 

WHEELS(49)

 on the 

FRONT STABILIZER(3).

The safety and integrity designed into the 

CPS 9300 Indoor Cycle

 can only be maintained when the 

CPS 9300 Indoor Cycle

 is regularly examined for damage and wear. Special attention should be given 

to the following:

STORAGE

MAINTENANCE

14

1.  Adjust the 

TENSION KNOB(34)

 and verify that the Flywheel System provides tension. The Flywheel 

System should provide many years of use.

2.  Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that 

the left pedal has left hand threads and is tightened by turning counterclockwise. The right pedal has 

right hand threads that are tightened by turning clockwise.

3.  Verify that the 

WARNING LABEL(70, 71)

 is in place and easy to read. Call Stamina Products immediately 

at 1-800-375-7520 for a replacement 

WARNING LABEL(70, 71)

 if it is missing or damaged.

4.  It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

5.  Worn or damaged components shall be replaced immediately or the 

CPS 9300 Indoor Cycle

 removed 

from service until repair is made.

6.  Only Stamina Products supplied components shall be used to maintain/repair the 

CPS 9300 Indoor 

Cycle.

7.  Keep your 

CPS 9300 Indoor Cycle

 clean by wiping it off with an absorbent cloth after use.