Stamina 35-1052, Owner'S Manual

OPERATIONAL INSTRUCTIONS

AAA Batteries

HOW TO INSTALL AND REPLACE BATTERIES:

1. Open the Battery Door on the back of the meter.

2. The  meter  operates  with  two AAA  batteries  (1.5V  each),  the 

batteries are not included. Refer to the illustration to install or 

replace the batteries.

1.  Do not mix a new battery with an old battery.

2.  Use the same type of battery. Do not mix an alkaline battery with 

another type of battery.

3.  Rechargeable batteries are not recommended.

4. Ultimate disposal of battery should be handled according to 

all state and federal laws and regulations.

5.  Do not dispose of batteries in fire.

NOTE:

14

NOTE:

1.  You may preset values for several functions. The preset function values will start to count down. When 

you complete one of the preset functions, the value of this completed function will start to count up, 

while the other preset functions will continue to count down.

2.  The Meter will shut off automatically after 4 minutes of inactivity. All function values will be reset to 

zero, except 

TOTAL COUNT.

3. The 

TOTAL COUNT

 will be reset to zero after batteries are removed for battery replacement or 

storage of the unit.

LOAD ADJUSTMENT

The resistance of the Shock can be adjusted by twisting the Adjustment 

Knob at the top of the Shock. There are settings from 1 to 12. Setting #1 

will provide the lowest resistance. Setting #12 will provide the highest 

resistance.

CAUTION:

  The shock gets 

HOT

 after a few minutes of use.

Adjustment

Knob

Mark