OPERATIONAL INSTRUCTIONS
8
USING THE ELECTRONIC TIMER
NOTE:
Rechargeable batteries are not recommended.
1. Open the Battery Door on the back of the timer.
2. The timer operates with one AAA battery, one battery included.
Refer to the illustration to install or replace the battery.
HOW TO INSTALL AND REPLACE BATTERIES:
AAA Battery
The safety and integrity designed into the
inStride® Foldaway Step'n Tone
can only be maintained
when the
inStride® Foldaway Step'n Tone
is regularly examined for damage and wear. Special
attention should be given to the following:
1. Inspect the
RESISTANCE BANDS(33, 34)
and
RESISTANCE HAND STRAPS(19)
for nicks and cuts.
Replace damaged
RESISTANCE BANDS(33, 34)
and
RESISTANCE HAND STRAPS(19).
2. Verify that the
WARNING LABEL(27)
is in place and easy to read. Call Stamina Products immediately
at
1-800-375-7520
for a replacement
WARNING LABEL(27)
if it is missing or damaged.
3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
4. Worn or damaged components shall be replaced immediately or the
inStride® Foldaway Step'n
Tone
removed from service until repair is made.
5. Only Stamina Products supplied components shall be used to maintain/repair the
inStride®
Foldaway Step'n Tone.
6. Keep your
inStride® Foldaway Step'n Tone
clean by wiping it off with an absorbent cloth after use.
MAINTENANCE
1. To time your workout, begin by pressing and holding the
button on the face of the timer until zeros are displayed.
Release the button.
2. Start the timer by pressing and releasing the button. Now you
are ready to begin your workout.
3. To stop or pause the timer, press and release the timer button.
This freezes the workout time. To resume your workout without
losing the time displayed before stopping or pausing, press
and release the button again.
4. When you complete your workout, press and release the timer
button. The timer will automatically turn off after being in stop
or pause mode for 4 minutes.
TIMER Function:
The electronic timer displays minutes and
seconds up to 99.59.
NOTE:
Even after the timer automatically turns off, the time that was displayed prior to shut off will
remain in memory. To resume your workout without losing the time displayed before stopping,
press and release the timer button. To clear the time and start a new workout, press the timer
button and hold it down for two seconds.